This panel supports various modes of operation to assist in the calibration of the Z axis of the machine. It's strongly suggested to read Klipper documentation about Bed level
- "Start" will initiate the only method available, or ask the user if multiple methods are available.
KlipperScreen will home if needed and move to the middle of the bed, but the location can be configured in KlipperScreen.conf
- The raise(+) and lower(-) buttons send
TESTZ Z=distancewhere distance is selected in the bottom row.
- Accept will send
- Abort will send
Available when an physical endstop is defined for
See Klipper documentation: Calibrating a Z endstop
Available when a probe is defined. (BL-Touch is a probe)
See Klipper documentation: Calibrating probe Z offset
Bed mesh (
Available when a probe is not defined and
[bed_mesh] is defined
this mode lets you create a mesh leveling bed using the paper test in various points.
DO NOT adjust the bed screws while using this mode.
Adjust the screws using the bed screws panel before running this tool.
Delta Automatic/Manual (
Available when the kinematics are defined as delta.
See Klipper documentation: Delta calibration
KlipperScreen will automatically Home(
G28) if needed