Skip to content

KlipperScreen

KlipperScreen is a touchscreen GUI that interfaces with Klipper via Moonraker. It can switch between multiple printers to access them from a single location, and it doesn't even need to run on the same host, you can install it on another device and configure the IP address to access the printer.

Required Hardware

KlipperScreen should run on any touchscreen that you can connect to a host (Raspberry, PC, Tablet), but not screens that connect directly to the printer MCU board.

A physical touchscreen is not strictly required, for example you may install a remote desktop server like tigervnc-scraping-server and connect from a client device, check out the hardware page for further information.

Sample Panels

Main Menu

Main Menu

Job Status

Job Status

More

Inspiration

KlipperScreen was inspired by OctoScreen and the need for a touchscreen GUI that will natively work with Klipper and Moonraker.

About the project

KlipperScreen has been created and maintained by Jordan Ruthe from 2020 to 2021

Donate to Jordan: Patreon Ko-fi

The current maintainer is Alfredo Monclus (alfrix) from 2021 onwards

Donate to Alfredo: Ko-fi

thanks to all the contributors who helped along the way.

Sponsors

LDO

Thank you LDO for sponsoring KlipperScreen and the open source community.

Thanks YUMI 3D-EXPERT.FR for sponsoring KlipperScreen and the open source community.