Panels
Main Menu
Job Status

Bed Level

The bed level panel has the ability to have preset locations from Klipper. Please see documentation on the following Klipper Sections: * bed_screws * screws_tilt_adjust
Important Note: Due to Klipper using the bltouch/probe offsets in screws_tilt_adjust, if a bltouch/probe is enabled KlipperScreen will add the offset to the defined screw values. This will not occur if bed_screws section is used.
This panel will favor screws_tilt_adjust over the bed_screws section. If screws_tilt_adjust is defined, an extra button for Screws Calibrate will appear. This button runs the SCREWS_TILT_CALCULATE command and shows the results on the panel.
Bed Mesh

Extrude

Fan

Fine Tune

Gcode Macros

Menu
Move

Network

Power


Settings

System

Temperature

Z Calibrate

Limits

Retraction

Input Shapers
